ET69C02 FAQ

I am currently using your ET69C02 to successfully control our heat pump via Modbus RTU to TCP.
I would like to add your R4IVB02 to the same RS485 A/B bus.
My current configuration for controlling the Heatpump only is:
Baud rate: 9600
Data bits: 8
Parity: None
Stop bits: 1
Work Mode: TCP Server, Port 8887
Modbus TCP to RTU: Open
Modbus Mode: Simple
Address Filter: 0
Heat pump Slave ID: 1
R4IVB02 planned Slave ID: 2
My question:
    Can the ET69C02 communicate with both Modbus RTU slaves (IDs 1 and 2) on the same A/B bus using this configuration? So two devices and just one ET69C02

Would it be possible to place the order directly here and have you configure them with Slave ID 2, as you kindly offered? Or should I place the order through your website and add a note requesting this configuration?

yes , it can , we can modify for you