RSA85 based

Dear Support Team,

I have purchased several of your boards for testing, as I need to deploy a system with 57 boards of 32 outputs each across four RS485 buses. My goal is to send commands to 1,800 outputs every 25 milliseconds.

I have set the baud rate to 115200 and attempted to reduce the delay between messages to 0 ms. However, I am unsure if there is an option to disable the response from the boards when sending commands using function 0x0F. This would help prevent bus saturation and optimize performance.

Is it possible to disable the response or reduce the 40ms wait time between commands?

Thank you for your assistance.

Best regards,

Answer : 

There is no product model, so I don't know which product it is for. I will answer the customer like this: 1 RS485 bus is a slow half-duplex bus. 2 It takes a certain amount of time to transmit and process data. So it is difficult to shorten the response time for this board.
Please enter the reply content...