SFWSC08 Schumann Generator manufacture Custom request 3 ( schumann generator manufacture - Eletechsup )
Share
Question ：
* A challenge for you * It's the weekend, take it easy.
Proposal for a new design of a second professional Schumann resonance generator
- Antenna 25 inch
- 8 antenna connections
- Button to set frequency (like previous model). After the click, the memory number 0 to 9 appears and you can choose between done or continue. Every time you continue, you can set a new frequency and the memory number increases.
- Button to set timer (number of seconds on - number of seconds off)
- Lithium battery built-in charging = red, full = green, active is (flashing) white.
- Lithium battery provided with black heat shrink tubing so that it looks neat that is attached to the printed circuit board with small tie-wraps.
- Plexiglas housing 2.8mm
Operation
Generator transmits set frequency from memory number 0 for the set time, then it stops for the set time.
then the generator transmits the frequency of memory number 1 if it is entered, again for the set time etc. etc.
I assume you are using a microcontroller (e.g. STM32)?
A question for a possible update in the future: Are you also able to make a carrier signal (AM = Amplitude modulation)? For example 100Khz with 100% carrier of 7.83Hz?
Request confirm :
1 Antenna 25CM.
2 8 antenna connections (8 audio output interfaces).
3 "- Button to set frequency (like previous model). After the click, the memory number 0 to 9 appears and you can choose between done or continue. Every time you continue, you can set a new frequency and the memory number increases." The specific operation method has changed.
4 - Button to set timer (number of seconds on - number of seconds off) 0 - 10000
5 - Lithium battery built-in charging = red, full = green, "
6 - Plexiglas housing 2.8mm"
7 Lithium battery provided with black heat shrink tubing so that it looks neat that is attached to the printed circuit board with small tie-wraps.”