1 3

Eletechsup Original Factory Official‌ Store

1 Ch Learning Function RF Wireless Receiver 433.92MHZ DC12V & 1 Buttons Keyfobs

1 Ch Learning Function RF Wireless Receiver 433.92MHZ DC12V & 1 Buttons Keyfobs

$20.98 USD
$20.98 USD $20.98 USD
Sale Sold out
1 Ch Learning Function RF Wireless Receiver 433.92MHZ DC12V & 1 Buttons Keyfobs
 
 
QTY: 1 pcs remotes and 1 pcs Receiver Controller .(this remote doesnot have a battery )
 

 

Receiver :
 

Technical indicators:

1.operating voltage: DC 12V ;       

2.working frequency:433.92MHz;
3:Maximum load: 1000 watts;
4:PCB Size:41×20×15mm;
5: Momentary Mode ,Latch Mode  , Toggle Mode can be adjustable by slodering back side.
6. Pls connect the receiver modules properly before power supply ;
8: Momentary Mode ,Latch Mode  , Toggle Mode can be adjustable by jumper .
9. Pls connect the receiver modules properly before power supply ;
10: 1 chanels;
11: Learning function (can works with EV1527 and PT2262 remote , can store 16 pcs different code remote );
Advantage :
1:  Receiver Mother board have a learning key , if the remote is lost , must buy EV1527 Learning remotes to re-learn;
 

Output:

A.singnal Inter-locking (Latch)----connect 1  and 2 ;

B.singnal Self-locking (Toggle) ---- connect 2 and 3 ;

C.singnal Non-locking (Momentary ) ---- All disconnect  ; 

·         Toggle : Press->On; Press again->Off ;

·         Latched : Press->On; Press other button->Off ;

·         Momentary : Press and hold->On; Release->Off ;

Relay mode :

 Normally close (NC ) ;
 Normally open (NO ) ;
  • Normally-open (NO) contacts connect the circuit when the relay is activated; the circuit is disconnected when the relay is inactive. It is also called a Form A contact or "make" contact. NO contacts may also be distinguished as "early-make" or NOEM, which means that the contacts close before the button or switch is fully engaged.
  • Normally-closed (NC) contacts disconnect the circuit when the relay is activated; the circuit is connected when the relay is inactive. It is also called a Form B contact or "break" contact. NC contacts may also be distinguished as "late-break" or NCLB, which means that the contacts stay closed until the button or switch is fully disengaged.
 

Learning method and steps

1.       Keep pressing learnig key on receiver board , release the button when LED is off , enter the learning state ;

2.       Press any key on remote control within 5 seconds , LED flash 3 times and then turn on , then it have success in learning .

Clear the deposit information

Keep Pressing Learning Key , LED turns off , Wait 10 Seconds , LED turn on , that deposited information has been successfully cleared ;

 
Connect to Power supply :
 

 

 
 Power supply : 12V 27A battery  replacable .(This remote doesnot have a battery , Please buy in your local market )
Operating current: ≤ 12mA;
Oscillation mode: SAW resonator;
Modulation mode:ASK;
Operating frequency:433.92MHZ ;
Encoding format:Fixed Code PT2260 PT2262 SC2262 . Cannot cloning or copy any remotes ;
Size: 58*39*14;
  
 
View full details